Page 2 of 2

Re: Iron Man Test

PostPosted: Sun Sep 29, 2019 9:34 am
by corelki2005
The led is tested

Re: Iron Man Test

PostPosted: Sun Sep 29, 2019 9:36 am
by corelki2005
Finally what they call the vamp is affixed (magnetic cover)

Re: Iron Man Test

PostPosted: Sun Sep 29, 2019 9:43 am
by corelki2005
The only downside I can see is the scale of the model

I think this model is around 1/3 scale as it is approx. 600mm tall. It should of been 1/2 scale 900mm tall, then it would be similar to the Terminator :D

At present I haven't decided whether to actual continue with this if it goes live.

Re: Iron Man Test

PostPosted: Mon Sep 30, 2019 5:50 am
by Mark
That's looking really good. Looks nice quality and well finished.

Re: Iron Man Test

PostPosted: Thu Oct 10, 2019 5:00 pm
by corelki2005
issue 3 - the right gauntlet

the parts

Re: Iron Man Test

PostPosted: Thu Oct 10, 2019 5:01 pm
by corelki2005
first off the fingers and thumb are assembled

Re: Iron Man Test

PostPosted: Thu Oct 10, 2019 5:02 pm
by corelki2005
the diffuser was then added to the palm

Re: Iron Man Test

PostPosted: Thu Oct 10, 2019 5:03 pm
by corelki2005
the battery box was fitted to the outside of the palm

Re: Iron Man Test

PostPosted: Thu Oct 10, 2019 5:06 pm
by corelki2005
the fingers were then sandwiched between the two halves of the palm, the battery cover added and finally the hand guard attached

Re: Iron Man Test

PostPosted: Thu Oct 10, 2019 5:07 pm
by corelki2005
the gauntlet with the palm lit up

Re: Iron Man Test

PostPosted: Thu Oct 10, 2019 5:09 pm
by corelki2005
if this is a 4 issue test run then hopefully next week I should have the arc reactor

Re: Iron Man Test

PostPosted: Thu Oct 17, 2019 3:14 pm
by corelki2005
Issue 4 - the arc reactor - the last of the test issues

not a lot to do in this issue compared to the previous three.

parts

Re: Iron Man Test

PostPosted: Thu Oct 17, 2019 3:15 pm
by corelki2005
The inner ring and the diffuser were inserted into the main ring and then secured

Re: Iron Man Test

PostPosted: Thu Oct 17, 2019 3:16 pm
by corelki2005
the led was inserted into the support disc

Re: Iron Man Test

PostPosted: Thu Oct 17, 2019 3:18 pm
by corelki2005
a clear cover was then put over the led and the whole lot screwed together

Re: Iron Man Test

PostPosted: Thu Oct 17, 2019 3:19 pm
by corelki2005
the supplied batteries were then inserted, the cover attached and the switched on to test

Re: Iron Man Test

PostPosted: Thu Oct 17, 2019 3:23 pm
by corelki2005
there you have the four issues. If this goes live and after my routemaster is finished then I may subscribe to it

Re: Iron Man Test

PostPosted: Sat Oct 19, 2019 10:43 am
by steve131
Did part one myself ,quality excellent and very much enjoyed doing it . Would be a fun build, into a cracking model.

Re: Iron Man Test

PostPosted: Wed Oct 23, 2019 7:44 pm
by Narayan
Thanks for posting, this looks interesting. Hopefully it will go live.

Graham