TERMINATOR T-800 1/2 scale

[casper]

Now take the lower jaw form issue 6 and attach the head motor joint from issue 7, It just clips into place with four location pegs.

[casper]

Now to take the "lower jaw" assembly from issue 5 and after adding the two brass bushes screw them together. The bushes allow a nice stiff joint for the lower jaw to move.

[casper]

Issue 12
Assembling the right forearm

[casper]

This was the most challenging assembly so far but still fairly easy.
Each muscle spring has to be superglued in place before the small cover is screwed to the forearm

[Morris]

Been watching this one come together

[casper]

Issue 13
Assembling the neck and right finger

[casper]

After fitting the lower neck joint to the left side of the neck its added to the left side of the jaw assembly using two 6mm screws

[casper]

[casper]

Right side added using two 6mm screws. Looks really good apart from the join down the centre of the neck but If not showing on the front it would have been down the sides.

[casper]

[casper]

[casper]

dry fit looking good so far

[casper]

Now to add the push fit (Plastic) screw covers
I added a touch of superglue to the posts to secure them.

[casper]

Now I have my replacement issue 4 I can return to assembling the right upper arm

[casper]

simple assembly for the upper arm pistons, one small screw holds a rubber washer/grommet on the end to give a nice seal when pushed together.

[casper]

shoulder joint assembly. Black part was superglued into position using the four location pegs

[casper]

The two screws go in from the rear of the assembly so to hold them in place a little bit of blue tac was used till the front section was added and the whole thing was turned over and screwed down.

[casper]

[casper]

Back on track
Issue 14
Fourth Finger and Lower arm tubes

[casper]

Tubes are plastic