TERMINATOR T-800 1/2 scale

[casper]

[casper]

Finger

[casper]

As you can see in the above photo I cut two ends off the plastic tube, when I tried it the first time it was over size and the finger was too loose. The chrome studs are push fit but a touch of superglue to the posts makes sure they stay put.

left to dry

[casper]

what's this
opened the box containing issues 23-26 and found this box inside labeled 7th delivery gift. Not sure why its a gift as the T-800 comes with it anyway.
The contents are nicely packaged in a velvety box and and look the great when assembled apart from the join right down the middle along the top. The barrel has a thread to screw into the main body and the trigger assembly and grip are metal, the trigger works so this could be for the lights and sound affects






next to a 18" figure

[casper]

Issue 15 complete
right hand small finger and left head plate

[casper]

Issue 16
Assembly of the lower left arm

[casper]

connect parts to the muscle assembly using one Pm3x12mm screw

[casper]

Take the three rubber washers and screw then to the ends of the rods and push them home (loose snug fit)

[casper]

Issue 18
motor for the eye movement


first attach the motor support with two screws then add the motor

[casper]

the top jaw screws to the lower jaw assembly with three screws

[casper]

[casper]

Ok back to issue 17
fitting the sides of the head to the main head plate.

[casper]

also the three small wrist ball joints are screwed in place

[casper]

Issue 19
assembly of the head motor

[casper]

[casper]

Issue 20
assemble and mount the head motor support

[casper]

then fit the two brackets with four screws

[casper]

Issue 21
right shoulder joint and and skull assembly

[casper]

add the metal dowels to the head plate using a little superglue

[casper]

Attach the head plate making sure the step sits in place both sides, tricky to get lined up but a little force pushes it all home.
Then glue in the jaw bolt covers.